LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 5.7L (LS6)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Valve Rocker Arm and Push Rod Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the valve rocker arm covers. Refer to Valve Rocker Arm Cover Replacement - Left  or Valve Rocker Arm Cover Replacement - Right .
    IMPORTANT: Place the valve rocker arms, valve pushrods, and pivot support, in a rack so that they can be installed in the same location from which they were removed.
    Fig 1: View Of Rocker Arms & Bolts
    GM260140Courtesy of GENERAL MOTORS CORP.
  2. Remove the valve rocker arm bolts.
  3. Remove the valve rocker arms.
    4. Fig 2: View Of Valve Rocker Arm Pivot Support
    GM260141Courtesy of GENERAL MOTORS CORP.
  4. Remove the valve rocker arm pivot support.
    5. Fig 3: View Of Pushrods
    GM260142Courtesy of GENERAL MOTORS CORP.
  5. Remove the pushrods.
  6. Clean and inspect the valve rocker arms and pushrods. Refer to Valve Rocker Arm and Push Rods Cleaning and Inspection .
scientia non olet · About LEMON Manuals