Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
- Remove the positive crankcase ventilation (PCV) tube from the throttle body and rocker arm cover.
- Disconnect the spark plug wires from the ignition coils.
- Twist the spark plug wire boot 1/2 turn.
- Pull only on the boot in order to remove the wire from the ignition coil.
- Disconnect the ignition coil wire harness main electrical connector.
- Remove the ignition coil bracket studs.
- Remove the ignition coil bracket.
- Loosen the valve rocker arm cover bolts.
- Remove the valve rocker arm cover.
- Remove the gasket (1) from the rocker cover. Discard the OLD gasket.
- Remove the oil fill cap from the oil fill tube.
- DO NOT remove the oil fill tube, unless replacement is necessary due to signs of leakage.
- Clean and inspect the valve rocker arm cover. Refer to Valve Rocker Arm Cover Cleaning and Inspection .