LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 5.7L (LS6)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Level Indicator and Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Lubricate the O-ring seal with clean engine oil.
  2. Install the oil level indicator tube into position.
    Fig 1: Identifying Oil Level Indicator Tube
    GM1392838Courtesy of GENERAL MOTORS CORP.
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Insert the oil level indicator tube into the engine block until the collar is flush with the block.
  5. Lower the vehicle.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the oil level indicator tube bolt.

    Tighten:  Tighten the oil level indicator tube bolt to 25 N.m (18 lb ft).

    7. Fig 2: View Of Oil Level Indicator
    GM1392837Courtesy of GENERAL MOTORS CORP.
  7. Install the oil level indicator.
  8. Check the oil level and add if necessary.
  9. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals