LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 5.7L (LS6)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Oil Temperature Gage Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Locating Oil Cover, Gasket, Bolts & Oil Temperature Sensor
    GM1199304Courtesy of GENERAL MOTORS CORP.
  1. Install the engine oil temperature gage sensor (732).

    Tighten:  Tighten the engine oil temperature gage sensor to 20 N.m (15 lb ft).

  2. Connect the engine oil temperature gage sensor electrical connector.
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals