LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 5.7L (LS6)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement - Accessory >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Accessory Drive Belt Routing
    GM1392169Courtesy of GENERAL MOTORS CORP.
  1. Route the accessory drive belt around all the pulleys except the water pump pulley (2) and tensioner (1).
  2. Install a breaker bar with hex-head socket to the drive belt tensioner bolt.
  3. Rotate the drive belt tensioner clockwise in order to relieve tension on the drive belt tensioner.
  4. Install the accessory drive belt under the water pump pulley (2).
  5. Install the accessory drive belt onto the drive belt tensioner.
  6. Slowly release the tension.
  7. Remove the breaker bar and socket from the drive belt tensioner bolt.
  8. Install the air outlet duct. Refer to Air Cleaner Outlet Duct Replacement in Engine Controls - 5.7L.
  9. Inspect the accessory drive belt for correct alignment.
scientia non olet · About LEMON Manuals