Valve Rocker Arm Cover Installation - Left

WARNING: This page is about a different variant/trim than selected.

IMPORTANT:

All gasket surfaces should be free of oil or other foreign material during assembly.
DO NOT use the valve rocker arm cover gasket again.
The valve rocker arm cover bolt grommets may be used again.

Fig 1: View Of Valve Rocker Arm Cover Gasket

Courtesy of GENERAL MOTORS CORP.

Fig 2: Valve Cover To Cylinder Head View

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the cover bolts with grommets.
Tighten: Tighten the valve rocker arm cover bolts to 12 N.m (106 lb in).

Fig 3: View Of Ignition Coils

Courtesy of GENERAL MOTORS CORP.

Install the ignition coils, wire harness, and bolts onto the mounting bracket.
Tighten: Tighten the ignition coil bolts to 12 N.m (106 lb in).

Fig 4: Locating Ignition Coils, Bracket Assembly & Bolts

Courtesy of GENERAL MOTORS CORP.

Apply threadlock GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the threads of the bracket bolts.
Install the ignition coils and bracket assembly and bolts onto the rocker cover.
Tighten: Tighten the ignition coil bracket bolts to 12 N.m (106 lb in).
Install the crankcase ventilation hose.