LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 5.7L (LS6)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Piston, Connecting Rod, and Bearings Cleaning and Inspection >> Measuring Piston Ring End Gap

Measuring Piston Ring End Gap

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT:
    • Do not attempt to file the end of the piston ring to achieve the proper end gap clearance.
    • Measure the piston ring in the cylinder in which it will be used.
    Fig 1: View Of Upper/Lower Compression Rings & Marks
    GM1336810Courtesy of GENERAL MOTORS CORP.
  1. Identify the NEW upper and lower compression rings. The upper compression ring can be identified by a paint mark (3) located 180 degrees from the end gap. The lower compression ring can be identified by a paint mark (3) located 90 degrees from the end gap. Both rings should be installed with the orientation marks (1, 2) facing the top of the piston.
    2. Fig 2: Measuring Piston Ring End Gap
    GM4968Courtesy of GENERAL MOTORS CORP.
  2. Place the piston ring into the cylinder bore 6.5 mm (0.25 in) below the top of the ring travel area.
  3. Insert a feeler gage and measure the piston ring end gap. Refer to Engine Mechanical Specifications (LS6) .
scientia non olet · About LEMON Manuals