LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 5.7L (LS6)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different variant/trim than selected.
  1. Inspect the O-ring seal for cuts or damage. If the oil level indicator tube O-ring seal is not cut or damaged, it may be reused.
  2. Lubricate the O-ring seal with clean engine oil.
    Fig 1: Installing/Removing Oil Level Indicator Tube In Oil Pan
    GM1199290Courtesy of GENERAL MOTORS CORP.
  3. Install the O-ring seal onto the oil level indicator tube.
  4. Install the oil level indicator tube into the oil pan and rotate into the proper position.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the tube bolt to the right cylinder head.

    Tighten:  Tighten the oil level indicator tube bolt to 50 N.m (37 lb ft).

  6. Install the oil level indicator into the tube.
scientia non olet · About LEMON Manuals