LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 5.7L (LS6)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Cylinder Head Removal - Right

Cylinder Head Removal - Right

WARNING: This page is about a different variant/trim than selected.
  1. Remove the spark plugs from the cylinder head.
    2. IMPORTANT: The cylinder head bolts can NOT be used again. Install NEW cylinder head bolts during assembly.
    Fig 1: View Of Cylinder Head & Bolts
    GM260149Courtesy of GENERAL MOTORS CORP.
  2. Remove the cylinder head bolts.
    3. NOTE: After removal, place the cylinder head on two wood blocks to prevent damage to the sealing surfaces.
  3. Remove the cylinder head.
    4. Fig 2: View Of Right Cylinder Head Gasket And Alignment Pins
    GM63170Courtesy of GENERAL MOTORS CORP.
  4. Remove the gasket.
  5. Discard the gasket.
  6. Discard the cylinder head bolts.
scientia non olet · About LEMON Manuals