LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 5.7L (LS6)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Crankshaft and Bearings Cleaning and Inspection >> Cleaning Procedure

Cleaning Procedure

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: Use care when handling the crankshaft. Avoid damage to the bearing surfaces or the lobes of the crankshaft position reluctor ring. Damage to the teeth of the crankshaft position reluctor ring may effect On-Board Diagnostics (OBD) II system performance.
    Fig 1: View Of Crankshaft
    GM156153Courtesy of GENERAL MOTORS CORP.
  1. Clean the crankshaft with solvent.
  2. Thoroughly clean all oil passages and inspect for restrictions or burrs.
    3. CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.
  3. Dry the crankshaft with compressed air.
scientia non olet · About LEMON Manuals