Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Install a 5/8 inch washer (1) onto the J 38836 or equivalent. See Special Tools and Equipment .
The washer serves as a stop against the crankshaft face and will assist in installing the bearing to the proper depth.

Fig 1: Identifying J 38836
Courtesy of GENERAL MOTORS CORP.
Install the new pilot bearing (2) onto the tool.

Fig 2: Installing The New Pilot Bearing Into The Crankshaft Using J 38836

Courtesy of GENERAL MOTORS CORP.

Install the new pilot bearing into the crankshaft using the J 38836 . See Special Tools and Equipment .

Fig 3: Locating Clutch Pilot Bearing

Courtesy of GENERAL MOTORS CORP.

Inspect the clutch pilot bearing for proper installation.
A properly installed clutch pilot bearing will be installed until flush to the rear face of the crankshaft.