Transmission Final Test and Inspection
WARNING: This page is about a different variant/trim than selected.
Complete the following procedure after the transmission is installed in the vehicle:
- With the ignition OFF or disconnected, crank the engine several times. Listen for any unusual noises or evidence that any parts are binding.
- Start the engine and listen for abnormal conditions.
- While the engine continues to idle raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Inspect for fluid leaks while the engine is idling.
- Lower the vehicle.
- Perform a final inspection for the proper fluid level.
- Road test the vehicle.