LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> Transmission Internal Electrical Harness Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Internal Wiring Harness
    GM792825Courtesy of GENERAL MOTORS CORP.
  1. Install new O-ring seals (3) onto the internal wiring harness (2) if the O-rings were previously removed.
  2. Install the internal wiring harness (2) to the transmission.
    3. Fig 2: Installing Internal Wiring Harness Retainer
    GM812734Courtesy of GENERAL MOTORS CORP.
  3. Install the internal wiring harness retainer (2) to the internal wiring harness (1).
    4. Fig 3: View Of Transmission (Pan Removed)
    GM822499Courtesy of GENERAL MOTORS CORP.
  4. Connect the internal wiring harness to components (1-8).
    5. Fig 4: View Of Transmission Wiring Harness Connector & Locking Latch
    GM785868Courtesy of GENERAL MOTORS CORP.
  5. Connect the transmission wiring harness connector (1) to the transmission by rotating the locking latch (2) clockwise.
  6. Install the Transmission fluid pan and filter. Refer to Automatic Transmission Fluid/Filter Replacement .
scientia non olet · About LEMON Manuals