LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> Transmission Control Module (TCM) Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Pulling Retainer Away From Electrical Connector
    GM796810Courtesy of GENERAL MOTORS CORP.
  1. Unlock the transmission control module electrical connector by pulling the retainer (2) away from the electrical connector (1).
  2. IMPORTANT: Twisting or tilting of the transmission control module electrical connector while disconnecting may result in bent or misaligned electrical terminal pins.
  3. Carefully disconnect the electrical connector (1) from the transmission control module.
  4. Fig 2: Removing Transmission Control Module From Mounting Bracket
    GM796811Courtesy of GENERAL MOTORS CORP.
  5. Remove the transmission control module from the mounting bracket by pulling back on the retaining tabs (1) to release the control module.