LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> Torque Converter Clutch (TCC) Solenoid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission fluid pan and filter. Refer to Automatic Transmission Fluid/Filter Replacement .
    2. Fig 1: Disconnecting Electrical Wiring Harness Connector
    GM795920Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical wiring harness connector (1) from the torque converter clutch (TCC) pulse width modulation (PWM) solenoid valve (2).
    3. Fig 2: Locating Solenoid Retainer
    GM795835Courtesy of GENERAL MOTORS CORP.
  3. Using a small screwdriver or pick, remove the TCC PWM solenoid valve retainer from the control valve body.
    4. Fig 3: Removing TCC PWM Solenoid Valve
    GM792782Courtesy of GENERAL MOTORS CORP.
  4. Remove the TCC PWM solenoid valve (1) from the control valve body.
  5. Remove the O-ring seals (3-4) from the TCC PWM solenoid valve (1), ONLY if the O-rings are cut or worn.
scientia non olet · About LEMON Manuals