LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> Torque Converter Clutch (TCC) Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing TCC PWM Solenoid Valve
    GM792782Courtesy of GENERAL MOTORS CORP.
  1. Install new O-ring seals (3-4) to the torque converter clutch (TCC) pulse width modulation (PWM) solenoid valve (1), if the O-rings were previously removed.
  2. Install the TCC PWM solenoid valve (1) into the control valve body.
    3. Fig 2: Locating Solenoid Retainer
    GM795835Courtesy of GENERAL MOTORS CORP.
  3. Install the TCC PWM solenoid valve retainer into the control valve body.
    4. Fig 3: Connecting Electrical Wiring Harness Connector
    GM795920Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical wiring harness connector (1) to the TCC PWM solenoid valve (2).
  5. Install the transmission fluid pan and filter. Refer to Automatic Transmission Fluid/Filter Replacement .
scientia non olet · About LEMON Manuals