LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> Parking Pawl Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Parking Pawl
    GM830384Courtesy of GENERAL MOTORS CORP.
  1. Install the parking pawl (3).
  2. Install the pivot pin (1).
  3. Install the parking pawl spring (2). The straight end of the spring locates against the case and the hooked end locates over the parking pawl.
  4. Install the extension housing. Refer to Extension Housing and Seal Replacement .
  5. Install the transmission support. Refer to Transmission Support Replacement in Frame and Underbody.
  6. Remove the transmission jack.
  7. Install the transmission fluid pan. Refer to Automatic Transmission Fluid/Filter Replacement .
    8. Fig 2: Securing Front Propeller Shaft To Shift Control Lever With Mechanics Wire
    GM787650Courtesy of GENERAL MOTORS CORP.
  8. Remove the mechanics wire (2) securing front propeller shaft (1) to the shift control lever (3).
    9. Fig 3: View Of Propeller Shaft Coupler
    GM801931Courtesy of GENERAL MOTORS CORP.
  9. Install the propeller shaft coupler (1) to the transmission flange. Refer to Propeller Shaft Replacement (Automatic Transmission) , Propeller Shaft Replacement (Manual Transmission) or Propeller Shaft Replacement (CTS-V) in Driveline/Axle.
  10. Install the exhaust system. Refer to Exhaust System Replacement (LA3, LY9) , Exhaust System Replacement (LY7) or Exhaust System Replacement (LS6) in Engine Exhaust.
    11. Fig 4: Identifying Shift Linkage
    GM785877Courtesy of GENERAL MOTORS CORP.
  11. Place the transmission in the park position by rotating the shift shaft fully counter clockwise.
  12. Connect the shift linkage to the transmission.
    13. NOTE: Refer to Fastener Notice in Cautions and Notices.
  13. Install the transmission manual shift shaft nut.

    Tighten:  Tighten the transmission manual shift shaft nut to 15 N.m (11 lb ft).

  14. Fill the transmission to the proper level. Refer to Transmission General Specifications , Fluid Capacity Specifications  and Transmission Fluid Checking Procedure .
  15. Lower the vehicle.
scientia non olet · About LEMON Manuals