LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> Output Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission fluid pan and filter. Refer to Automatic Transmission Fluid/Filter Replacement .
    2. Fig 1: Disconnecting Electrical Wiring Harness Connector
    GM795914Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical wiring harness connector (3) from the output speed sensor (2).
    3. Fig 2: Removing Output Speed Sensor Bolt
    GM812728Courtesy of GENERAL MOTORS CORP.
  3. Remove the output speed sensor bolt (3).
  4. Remove the output speed sensor (2).
  5. Remove the output speed sensor spacer (1).
  6. Inspect the output speed sensor (2) for the following conditions:
    • Damaged or missing magnet
    • Damaged housing
    • Bent or missing electrical terminals
scientia non olet · About LEMON Manuals