LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> Output Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Output Speed Sensor Spacer
    GM812728Courtesy of GENERAL MOTORS CORP.
  1. Install the output speed sensor spacer (1).
  2. Install the output speed sensor (2).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the output speed sensor bolt (3).

    Tighten:  Tighten the output speed sensor bolt to 11 N.m (97 lb in).

    4. Fig 2: Connecting Electrical Wiring Harness Connector To Output Speed Sensor
    GM795914Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical wiring harness connector (3) to the output speed sensor (2).
  5. Install the transmission fluid pan and filter. Refer to Automatic Transmission Fluid/Filter Replacement .
scientia non olet · About LEMON Manuals