LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> Input Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission fluid pan and filter. Refer to Automatic Transmission Fluid/Filter Replacement .
    2. Fig 1: Disconnecting Electrical Wiring Harness Connector
    GM795916Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical wiring harness connector (1) from the input speed sensor (2).
    3. Fig 2: Removing Input Speed Sensor Bolt
    GM812729Courtesy of GENERAL MOTORS CORP.
  3. Remove the input speed sensor bolt (2).
  4. Remove the input speed sensor (1).
  5. Inspect the input speed sensor (1) for the following conditions:
    • Damaged or missing magnet
    • Damaged housing
    • Bent or missing electrical terminals
    • Metal contamination stuck to magnet
scientia non olet · About LEMON Manuals