LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> Input Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Input Speed Sensor
    GM812729Courtesy of GENERAL MOTORS CORP.
  1. Install the input speed sensor (1).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the input speed sensor bolt (2).

    Tighten:  Tighten the input speed sensor bolt to 11 N.m (97 lb in).

    3. Fig 2: Connecting Electrical Wiring Harness Connector
    GM795916Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical wiring harness connector (1) to the input speed sensor (2).
  4. Install the transmission fluid pan and filter. Refer to Automatic Transmission Fluid/Filter Replacement .
scientia non olet · About LEMON Manuals