LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> Floor Shift Control Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: Removing Shift Control Linkage Adjustment Nut
    GM785879Courtesy of GENERAL MOTORS CORP.
  2. Remove the shift control linkage adjustment nut.
  3. Disengage the shift control linkage rod from the shift control assembly.
  4. Lower the vehicle.
  5. Remove the shift control boot. Refer to Floor Shift Control Boot Replacement .
  6. Remove the center console assembly. Refer to Console Replacement - Front Floor in Instrument Panel, Gages and Console.
    7. Fig 2: Removing Electrical Connector From Shift Control Assembly
    GM796319Courtesy of GENERAL MOTORS CORP.
  7. Remove the electrical connector (1) from the shift control assembly.
  8. Disconnect the shift lock actuator electrical connector (2) at the shift control assembly.
    9. Fig 3: Removing 4 Nuts Securing Shift Control Assembly
    GM796320Courtesy of GENERAL MOTORS CORP.
  9. Remove the 4 nuts securing the shift control assembly to the tunnel reinforcement.
  10. Remove the shift control assembly from the vehicle.
scientia non olet · About LEMON Manuals