LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> Extension Housing and Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Drive Flange & Components
    GM822505Courtesy of GENERAL MOTORS CORP.
  1. Remove the drive flange (2) and seal (3). Refer to Drive Flange and Seal Replacement .
  2. Place a suitable jack under the transmission pan in order to support the transmission.
  3. Remove the transmission support. Refer to Transmission Support Replacement in Frame and Underbody.
  4. Place an drain pan under the extension housing.
    5. Fig 2: Removing Extension Housing Bolts
    GM801792Courtesy of GENERAL MOTORS CORP.
  5. Remove the extension housing bolts (35).
  6. The output shaft retainer will slide off the output shaft while removing the case extension housing.
  7. Remove the extension housing (27) and the seal (25).
scientia non olet · About LEMON Manuals