LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> Extension Housing and Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Output Shaft Thrust Washer
    GM830379Courtesy of GENERAL MOTORS CORP.
  1. Install the output shaft thrust washer to the back side of the case extension housing prior to installing of the case extension housing. Align the thrust washer tabs with the locating slots on the case extension housing.
    2. Fig 2: Installing Extension Housing And Seal
    GM801792Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The case extension gasket seal is reusable. Replace the gasket ONLY if the sealing surface is damaged.
  2. Install the extension housing (27) and the seal (25).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the extension housing bolts (35).

    Tighten:  Tighten the bolts to 22 N.m (16 lb ft).

  4. Install the transmission support. Refer to Transmission Support Replacement in Frame and Underbody.
  5. Remove the transmission jack.
    6. Fig 3: View Of Drive Flange & Components
    GM822505Courtesy of GENERAL MOTORS CORP.
  6. Install the drive flange (2) and seal (3). Refer to Drive Flange and Seal Replacement .
scientia non olet · About LEMON Manuals