LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> Control Valve Body Accumulator Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission fluid pan and filter. Refer to Automatic Transmission Fluid/Filter Replacement .
    2. Fig 1: View Of Transmission (Pan Removed)
    GM822499Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the internal electrical wiring harness connectors from all internal electrical components (1-8).
    3. Fig 2: Removing Bolts 1 & 3 From Valve Body Assembly
    GM812785Courtesy of GENERAL MOTORS CORP.
  3. Remove ONLY bolts (1, 3) from the valve body assembly. Do NOT remove bolts (2) called out in the graphic.
    4. Fig 3: Removing Bolts Securing Control Valve Body Accumulator Assembly
    GM812731Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolts (3) securing the control valve body accumulator assembly (1) and manual shaft detent assembly (2) to the transmission case.
  5. Remove the manual shaft detent assembly (2) and control valve body accumulator assembly (1) from the transmission.
    6. Fig 4: Removing Fluid Passage Sleeves Only If Replacement Of Sleeves Is Necessary
    GM812730Courtesy of GENERAL MOTORS CORP.
  6. Remove the fluid passage sleeves only if replacement of the sleeves is necessary.
scientia non olet · About LEMON Manuals