LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> Control Valve Body Accumulator Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing New Fluid Passage Sleeves
    GM812730Courtesy of GENERAL MOTORS CORP.
  1. Install NEW fluid passage sleeves if previously removed.
    2. Fig 2: Installing Control Valve Body Accumulator Assembly
    GM812731Courtesy of GENERAL MOTORS CORP.
  2. Install the control valve body accumulator assembly (1) and manual shaft detent spring (2) to the transmission.
  3. Install the manual shaft detent spring bolts (3) and hand tighten.
    4. Fig 3: Confirming Manual Shift Shaft Detent Lever Locating Pin Is Properly Engaged With Manual Valve Link
    GM795843Courtesy of GENERAL MOTORS CORP.
  4. Confirm that the manual shift shaft detent lever locating pin (2) is properly engaged with the manual valve link (1).
  5. Confirm that the detent spring roller (4) is properly engaged with the manual shift shaft switch (3).
    6. Fig 4: Installing Control Valve Body Accumulator Assembly To Transmission Case Bolts
    GM812785Courtesy of GENERAL MOTORS CORP.
  6. Install the control valve body accumulator assembly to the transmission case bolts (1-3) and hand tighten.
    7. Fig 5: Tightening Control Valve Body Assembly Bolts In Sequence
    GM802251Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: If the bolts are tightened at random, valve bores may become distorted and inhibit proper valve operation.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Tighten the control valve body assembly bolts in sequence.

    Tighten:  Tighten the bolts to 11 N.m (97 lb in).

    8. Fig 6: Installing 0.8 mm Spacer Between Manual Shaft Detent Lever
    GM822502Courtesy of GENERAL MOTORS CORP.
  8. Install a 0.8 mm spacer (2) between the manual shaft detent lever (1) and the manual shaft detent spring (3).
  9. Tighten the detent spring bolts.

    Tighten:  Tighten the bolts to 11 N.m (97 lb in).

  10. Remove the spacer (2).
    11. Fig 7: View Of Transmission (Pan Removed)
    GM822499Courtesy of GENERAL MOTORS CORP.
  11. Connect the internal electrical wiring harness connectors to all internal electrical components (1-8).
  12. Install the transmission fluid pan and filter. Refer to Automatic Transmission Fluid/Filter Replacement .
scientia non olet · About LEMON Manuals