LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> 2-3 Shift Solenoid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission fluid pan. Refer to Automatic Transmission Fluid/Filter Replacement .
    2. Fig 1: Disconnecting Electrical Wiring Harness Connector
    GM795839Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical wiring harness connector (1) from the 2-3 shift solenoid (2).
    3. Fig 2: Locating Solenoid Retainer
    GM795835Courtesy of GENERAL MOTORS CORP.
  3. Using a small screwdriver or pick, remove the 2-3 shift solenoid retainer from the control valve body.
    4. Fig 3: Removing 2-3 Shift Solenoid From Control Valve Body
    GM792791Courtesy of GENERAL MOTORS CORP.
  4. Remove the 2-3 shift solenoid (7) from the control valve body.
  5. Remove the O-ring seals (4-5) from the 2-3 shift solenoid (7) ONLY if the O-rings are cut or worn.
scientia non olet · About LEMON Manuals