LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls - 5.7L - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) System Hoses/Pipes Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Position the EVAP hose to the fuel tank.
    2. Fig 1: View Of EVAP Hose Retainers
    GM818893Courtesy of GENERAL MOTORS CORP.
  2. Install the chassis to canister evaporative emission (EVAP) hose to the following:
    • The body retainer (1)
    • The 3 retaining features (2) on the fuel tank
    • The retainer clip (3)
  3. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals