LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls - 5.7L - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing EVAP Canister Purge Valve To Purge Bracket
    GM419407Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister purge valve to the purge bracket.
  2. Connect the harness connector to the EVAP canister purge valve.
    3. Fig 2: Connecting Fuel Injector Wire Harness Retainers To Fuel Rail
    GM419425Courtesy of GENERAL MOTORS CORP.
  3. Connect the fuel injector wire harness retainers to the fuel rail.
  4. Connect the engine purge pipe to the chassis purge pipe. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  5. Connect the engine vacuum pipe to the EVAP canister purge valve. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    6. Fig 3: Installing Fuel Injector Sight Shield
    GM1392497Courtesy of GENERAL MOTORS CORP.
  6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 5.7L.
scientia non olet · About LEMON Manuals