LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 3.6L - Introduction) >> Repair Instructions >> Knock Sensor (KS) Replacement - Bank 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the KS.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of Right Knock Sensor & Bolt
    GM860801Courtesy of GENERAL MOTORS CORP.
  2. Install the KS bolt.

    Tighten:  Tighten the KS bolt to 23 N.m (17 lb ft).

    3. Fig 2: View Of Right Knock Sensor And Electrical Connector
    GM945742Courtesy of GENERAL MOTORS CORP.
  3. Install the KS electrical connector.
  4. Install the wiring harness heat shield to the original position.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals