LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 3.6L - Introduction) >> Repair Instructions >> Ignition Coil(s) Replacement - Bank 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Ignition Coil View
    GM860797Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coil(s).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the ignition coil bolt(s).

    Tighten:  Tighten the ignition coil bolt(s) to 10 N.m (89 lb in).

    3. Fig 2: View Of Ignition Coil Electrical Connectors
    GM887888Courtesy of GENERAL MOTORS CORP.
  3. Install the ignition coil electrical connector(s).
  4. If necessary, install the intake manifold. Refer to Intake Manifold Replacement - Lower in Engine Mechanical - 3.6L (LY7).
  5. Install the engine cover. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 3.6L (LY7).
scientia non olet · About LEMON Manuals