LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 3.6L - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister Retaining Nuts
    GM785820Courtesy of GENERAL MOTORS CORP.
  1. Complete the following in order to install the EVAP canister:
    1. Insert the fresh air tube and tab on the canister forward into the body brace.
    2. Rotate the rear of the canister up over the 2 weld studs on the floor pan.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the EVAP canister retaining nuts.

    Tighten:  Tighten the EVAP canister retaining nuts to 6 N.m (53 lb in).

    3. Fig 2: Identifying EVAP Hoses At EVAP Canister
    GM785817Courtesy of GENERAL MOTORS CORP.
  3. Connect the EVAP hoses to the EVAP canister.
  4. Connect the electrical connector to the EVAP canister.
  5. Install the rear frame. Refer to Frame Replacement - Rear in Frame and Underbody.
scientia non olet · About LEMON Manuals