LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 3.6L - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition OFF.
    2. Fig 1: Top Of Engine View
    GM1348201Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the purge line (3) from the purge valve solenoid.
    3. Fig 2: View Of Purge Solenoid Valve And Electrical Connector
    GM887878Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the purge valve solenoid electrical connector.
    4. Fig 3: Disconnecting Purge Line From Manifold Side Of Purge Valve Solenoid
    GM1344143Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the purge line from the manifold side of the purge valve solenoid.
  5. Remove the purge valve solenoid from the bracket.
scientia non olet · About LEMON Manuals