LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 3.6L - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Purge Valve Solenoid To Bracket
    GM1344143Courtesy of GENERAL MOTORS CORP.
  1. Install the purge valve solenoid to the bracket.
  2. Disconnect the purge line from the manifold side of the purge valve solenoid.
    3. Fig 2: View Of Purge Solenoid Valve And Electrical Connector
    GM887878Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the purge valve solenoid electrical connector.
    4. Fig 3: Top Of Engine View
    GM1348201Courtesy of GENERAL MOTORS CORP.
  4. Connect the purge line (3) to the purge valve solenoid.
scientia non olet · About LEMON Manuals