LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 3.6L - Introduction) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition OFF.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Reposition the wiring harness heat shield to obtain access.
    4. Fig 1: Disconnecting Crankshaft Position (CKP) Electrical Connector
    GM887868Courtesy of GENERAL MOTORS CORP.
  4. Disconnecting crankshaft position (CKP) electrical connector (3).
    5. Fig 2: Removing Crankshaft Sensor Bolt
    GM1311144Courtesy of GENERAL MOTORS CORP.
  5. Remove the crankshaft sensor bolt.
  6. Remove the crankshaft sensor.
scientia non olet · About LEMON Manuals