LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 3.6L - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement - Bank 1 (Right) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition OFF.
    2. Fig 1: Removing Camshaft Position (CMP) Sensor Electrical Connector
    GM1285245Courtesy of GENERAL MOTORS CORP.
  2. Remove the camshaft position (CMP) sensor electrical connector.
    3. Fig 2: Removing CMP Sensor Bolt
    GM1285251Courtesy of GENERAL MOTORS CORP.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.
scientia non olet · About LEMON Manuals