LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 3.6L - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement - Bank 1 (Right) Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing CMP Sensor
    GM1285252Courtesy of GENERAL MOTORS CORP.
  1. Install the CMP sensor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CMP sensor bolt.

    Tighten:  Tighten the CMP sensor bolt to 10 N.m (89 lb in).

    3. Fig 2: Installing CMP Sensor Electrical Connector
    GM1285253Courtesy of GENERAL MOTORS CORP.
  3. Install the CMP sensor electrical connector.
  4. Install the ECM bracket with the ECM. Refer to Engine Control Module (ECM) Replacement .
scientia non olet · About LEMON Manuals