LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 3.6L - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Actuator Solenoid Replacement - Bank 2 (Left) Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing CMP Actuator Valve
    GM1285231Courtesy of GENERAL MOTORS CORP.
  1. Install the CMP actuator valve.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CMP actuator valve bolt.

    Tighten:  Tighten the CMP actuator valve bolt to 10 N.m (89 lb in).

    3. Fig 2: Installing CMP Actuator Valve Electrical Connector
    GM1285203Courtesy of GENERAL MOTORS CORP.
  3. Install the CMP actuator valve electrical connector.
  4. Install the power steering fluid reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement (LY7) , Remote Power Steering Fluid Reservoir Replacement (LA3/LY9) or Remote Power Steering Fluid Reservoir Replacement (5.7L) in Power Steering System.
scientia non olet · About LEMON Manuals