LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 3.6L - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Actuator Solenoid Replacement - Bank 1 (Right) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition OFF.
    2. IMPORTANT: Do not remove the engine control module (ECM) from the ECM bracket.
    Do not remove the ECM redundant ground wire from the ECM.
  2. Remove the ECM bracket bolts and reposition the ECM bracket in order to provide access.
    3. Fig 1: Removing Camshaft Position (CMP) Actuator Valve Electrical Connector
    GM1285235Courtesy of GENERAL MOTORS CORP.
  3. Remove the camshaft position (CMP) actuator valve electrical connector.
    4. Fig 2: Removing CMP Actuator Valve Bolt
    GM1285237Courtesy of GENERAL MOTORS CORP.
  4. Remove the CMP actuator valve bolt.
  5. Remove the CMP actuator valve.
scientia non olet · About LEMON Manuals