LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 3.6L - Introduction) >> Repair Instructions >> Barometric Pressure (BARO) Sensor Replacement (LY7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the barometric pressure sensor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Installing Barometric Pressure Sensor Bolt
    GM1285192Courtesy of GENERAL MOTORS CORP.
  2. Install the barometric pressure sensor bolt.

    Tighten:  Tighten the barometric pressure sensor bolt to 10 N.m (89 lb in).

    3. Fig 2: Identifying Barometric Pressure Sensor And Electrical Connector
    GM945437Courtesy of GENERAL MOTORS CORP.
  3. Install the sensor electrical connector.
scientia non olet · About LEMON Manuals