Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

No throttle system DTC P0120.
No ISS DTCs P0716 or P0717.
No OSS DTCs P0722 or P0723.
No TCC performance DTC P0742.
No IMS DTCs P1815, P1820, P1822, P1823, P1825 or P1826.
No engine torque signal circuit DTC P2637.
No TCC solenoid electrical DTCs P2763 or P2764.
The engine run time is greater than 5 seconds.
The IMS range is D2, D3, D4, or D5.
The elapsed time since the most recent range change is greater than 6 seconds.
The transmission fluid temperature is 20-130°C (68-266°F).
The engine torque is greater than 55 N.m (41 lb ft).
The throttle position is 12-90 percent.
The gear ratio is within the following ranges:
- 1.56:1 to 1.64:1 - 3rd gear
- 0.98:1 to 1.03:1 - 4th gear
- 0.73:1 to 0.77:1 - 5th gear
The TCC apply pressure is greater than 150 kPa (22 psi) for more than 5 seconds.
The TCC duty cycle is greater than 80 percent for more than 5 seconds.