Conditions for Running the DTC

DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0125, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P0140, P0141, P0151, P0152, P0153, P0154, P0155, P0157, P0158, P0160, P0161, P0200, P0442, P0443, P0446, P0449, P0455, P0496, P1133, P1134, P1153, P1154 are not set.

Passive Test

• The engine is running.
• The Engine Run Time parameter is less than 13.5 minutes.

Intrusive Test

• The Engine Run Time parameter is more than 13.5 minutes.
• The ignition 1 Signal parameter is between 10-18 volts.
• The Engine Speed parameter is between 500-5,000 RPM.
• The MAF Sensor parameter is between 5-55 g/s.
• The Vehicle Speed parameter is between 24-131 km/h (15-82 mph).
• The Short Term FT Bank 1 and Bank 2 parameter is between -10 and +10 percent.
• The maximum number of intrusive attempts is less than 13.