Circuit Description
WARNING: This page is about a different variant/trim than selected.
The ignition system on this engine uses individual ignition coils and ignition control (IC) circuits for each cylinder. The engine control module (ECM) controls the ignition system operation. The ECM controls each coil using the IC circuits. The ECM commands the IC circuit low when a spark event is requested. Each ignition coil is supplied the following circuits:
- The ignition control circuit
- The ignition 1 voltage circuit
- Two ground circuits
The sequencing and timing are ECM controlled. If the ECM detects the ignition control circuit is shorted to voltage, this DTC sets.