Diagnostic Aids

WARNING: This page is about a different variant/trim than selected.

Use the J 35616 Connector Test Adapter Kit for any test that requires probing the ECM harness connector or a component harness connector.
The lower connector of the ECM is connector C1 and the upper connector of the ECM is connector C2. Refer to Engine Controls Component Views .
The KS must be torqued correctly. Refer Fastener Tightening Specifications .
The mounting between the sensor and engine must be free of burrs, casting flash, and foreign material.
The KS is clear from hoses, brackets, and engine wiring.
The normal KS signal voltage is 0.25 volts when the KS is disconnected.
For an intermittent condition, refer to Intermittent Conditions .