Test Description
WARNING: This page is about a different variant/trim than selected.
The numbers below refer to the step numbers on the diagnostic table.
- 2: This step determines if a condition exists.
- 3: A crankshaft sensor DTC could cause this DTC to set.
DTC P0324
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you perform the Diagnostic System Check-Engine Controls? | Go to Step 2 | Go to Diagnostic System Check - Engine Controls |
| 2 |
IMPORTANT:
If you can hear an engine knock, repair the engine mechanical condition before proceeding with this diagnostic. Refer to Symptoms - Engine Mechanical
in Engine Mechanical-3.6L (LY7).
|
Go to Step 3 | Go to Intermittent Conditions |
| 3 | Is DTC P0335, P0336, or P0338 also set? | Go to Diagnostic Trouble Code (DTC) List | Go to Step 4 |
| 4 | Replace the engine control module (ECM). Refer to Engine Control Module (ECM) Replacement
. Did you complete the replacement? |
Go to Step 5 | - |
| 5 |
|
Go to Step 2 | Go to Step 6 |
| 6 | Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? |
Go to Diagnostic Trouble Code (DTC) List | System OK |