Diagnostic Aids
WARNING: This page is about a different variant/trim than selected.
- Use the J 35616 Connector Test Adapter Kit for any test that requires probing the ECM harness connector or a component harness connector.
- The lower connector of the ECM is connector C1 and the upper connector of the ECM is connector C2. Refer to Engine Controls Component Views .
- Inspect for mis-routed harnesses. Inspect the MAF sensor harness for routing that is too close to the following components:
- Ignition coils
- Solenoids
- Relays
- Motors
- For an intermittent condition, refer to Intermittent Conditions .