Diagnostic Aids
WARNING: This page is about a different variant/trim than selected.
- Use the J 35616 Connector Test Adapter Kit for any test that requires probing the ECM harness connector or a component harness connector.
- The lower connector of the ECM is connector C1 and the upper connector of the ECM is connector C2. Refer to Engine Controls Component Views .
- Any un-metered air that enters the engine may cause this DTC to set.
- Inspect the throttle plate for sticking, or for deposits on the throttle plate, or in the throttle bore.
- For an intermittent condition, refer to Intermittent Conditions .