Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

Before the ECM can report DTC P0011, P0014, P0021, or P0024 failed, DTCs P0010, P0013, P0020, P0023, P0342, P0343, P0347, P0348, P0367, P0368, P0392, P0393, P2088, P2089, P2090, P2091, P2092, P2093, P2094, and P2095 must run and pass.
The engine must accelerate such that the CMP actuator system is commanded from the park position to the phased position. This is considered a cam control cycle. There must be a total of 5 cam control cycles for at least 10 seconds each in the phased position.
The engine speed is more than 1,000 RPM.
The engine is operating for approximately 5 minutes.
DTCs P0011, P0014, P0021, and P0024 run continuously once the above conditions are met for more than 1 second.