Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

Before the ECM can report DTC P0506 or P0507 failed, transmission DTCs P0722 and P0723 must run and pass.
DTCs P0112, P0113, P0117, P0118, P0121, P0122, P0123, P0221, P0222, P0223, P0442, P0443, P0446, P0455, P0458, P0459, P0496, P0722, and P0723 are not set.
The engine coolant temperature (ECT) is more than 60°C (140°F).
The intake air temperature (IAT) is more than -10.5°C (+13°F).
The volumetric efficiency is less than 35 percent, DTC P0506 only.
The evaporative emission (EVAP) canister purge valve is OFF.
A vehicle speed was detected prior to the diagnostic running.
The vehicle speed is 0 km/h (0 mph).
DTC P0506 and P0507 run continuously once the above conditions are met.