Test Description
WARNING: This page is about a different variant/trim than selected.
The number below refers to the step number on the diagnostic table.
- 2: Performing this step helps verify that an external anomaly, such as Electromagnetic Interference (EMI), did not cause the code to set originally.
DTC P1621
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| 1 | Did you perform the Diagnostic System Check - Automatic Transmission? | - | Go to Step 2 | Go to Diagnostic System Check - Automatic Transmission |
| 2 |
IMPORTANT:
|
- | Go to Step 3 | Go to Intermittent Conditions in Engine Controls - 2.6L and 3.2L or Diagnostic Trouble Code (DTC) List in Engine Controls - 3.6L (LY7) |
| 3 | Replace the TCM. Refer to Transmission Control Module (TCM) Replacement
. Is the action complete? |
- | Go to Step 4 | - |
| 4 | Perform the following procedures in order to verify the repair:
Has the test run and passed? |
Go to Step 5 | Go to Step 2 | |
| 5 | With the scan tool, observe the stored information, capture info and DTC info. Does the scan tool display any DTCs that you have not diagnosed? |
- | Go to Diagnostic Trouble Code (DTC) List in Engine Controls - 2.6L and 3.2L or Diagnostic Trouble Code (DTC) List in Engine Controls - 3.6L (LY7) | System OK |